Zoomed Reptile Heating Pad? - best reptile heating pad
Advanced ask hot towel under the tank, not just the heat of this part is in the book? If you have plastic tank liners sealants, rubber melt?
Friday, February 5, 2010
Best Reptile Heating Pad Zoomed Reptile Heating Pad?
4 comments:
The rubber gasket should be fine, but you really should not be in the vicinity of corners anyway. If there is a cold side and warm side, which is what. Try the middle of the platform or in the tank (if you say and do the room - even the instructions, they prefer) the side mount or on a page. And I do not mean the center to the center of the tank. I mean, read the middle of the tank. "
And I'm not sure what you mean by plastic liners, but it will melt the plastic. In particular, he does not warn of plastic, use everywhere. Plastic deformation is nothing - it's too hot.
I personally have my UTH on the back of my car, first.
The rubber gasket should be fine, but you really should not be in the vicinity of corners anyway. If there is a cold side and warm side, which is what. Try the middle of the platform or in the tank (if you say and do the room - even the instructions, they prefer) the side mount or on a page. And I do not mean the center to the center of the tank. I mean, read the middle of the tank. "
And I'm not sure what you mean by plastic liners, but it will melt the plastic. In particular, he does not warn of plastic, use everywhere. Plastic deformation is nothing - it's too hot.
I personally have my UTH on the back of my car, first.
It does not melt the rubber seal, but any plastic that can melt a little.
Make sure that you consider the right size pad that is less than half of the container floor. The reason for this is create a temperature gradient of snake / lizard is on the hottest area (go through the platform) or cooler areas to reach the other side of the tank. If any substance is called, you can create conditions too hot for your reptile
Zoo Med pads are covered with plastic and are at a certain temperature on the platform the size of the heat you have to heat. They are 4 sizes and each has a different voltage.
The pad will be heat only the area of the platform. You should no problem with the sealant, rubber or plastic coatings.
Post a Comment